Moment Redistribution is a Eurocode requirement. It allows for a shift of moments along the beams.This is done in the case the analysis is linear, to account for plastic

While the result of all engineering work is the final object (or structure) being built, what really comes out of an engineering office are documents: Calculation Reports, Drawings and

Slender columns! They are pretty rare for concrete structures but could be a difficult beast if you run into some. VIS can make their design easier for you. https://youtu.be/Z3kFc6QeSMw

Note that while for PMM Strength Check the solution is univocal, for Strength Design typically the solutions are infinite in number. https://www.youtube.com/watch?v=tV_Lyxu7qiw Before you watch this video, please first

SAP2000 and the other analysis programs calculate internal forces at a discreet number of stations along each structural member. One set of internal forces for each load combination. https://www.youtube.com/watch?v=k1GJqhAv_wQ

Reinforcement edit and final design follow the preliminary design phase. This is where you refine the reinforcement generated by the Wizard and adjust it to your actual needs. You

VIS design process unfolds through two phases: Preliminary Design and Editing of Reinforcing. Preliminary design is entirely automated. Once that’s done, the user steps in and runs the editing,

This video shows the GENERAL SETTINGS, which are needed to provide the VIS program with your specific project requirements. Hello there. This video shows the GENERAL SETTINGS, which are

Section cutter is a plug-in tool for the definition of wall assemblies. It is necessary only with SAP and CSiBridge. With ETABS, walls are defined directly within the main

Combinator is a plug-in tool for the generation of load combinations sets based on Eurocode provisions. SAP2000 and the other CSi programs allow for the automatic generation of a